az ru en

Products


Paints

MEGA Paints

FAB MEGA AQUA İPEKMAT






Single-component, ready to use water based mat looking pearly parquet varnish

DESCRIPTION:

Single-component, ready to use water based mat looking pearly parquet varnish

FEATURES:

Protecting natural look and color of the wood, odorless, ecologically pure and resistant to sunlight, fast drying and non-yellowing mat looking pearly parquet varnish with high physical and chemical resistance

APPLICATION AREA:

Be sure that the adhesive is fully dried on the surface subject to be applied with the primer. Clean surface of all kinds of dust, grease and dirt. The parquet should be sanded (100-200) to full smoothness, holes and defects should be filled with mixture of varnish and wood shavings or with LİON TAXTA MƏCUNU (355). Then the surface should be sanded (180-200) once more. It is recommended to sand with thinner sanding paper (300-400) in order to get ideal surface. Then clean the surface of sanding dust and apply MEGA AQUA ASTAR (446)

APPLICATION:

Wait until the temperature of MEGA AQUA İPƏKMAT (447) and room where it is used is equal. Do not add water to the primer and mix thoroughly. Apply 1 coat of primer and at least 2 coats of MEGA AQUA İPEKMAT (447) to the surface. In the areas with intense activity and in order to get ideal image on the surface it is recommended to apply the third coat of MEGA AQUA İPEKMAT (447). Within 2-3 hours (depending on room temperature) after MEGA AQUA ASTAR (446) has been applied and when the primer has not been dried yet first coat of MEGA AQUA İPEKMAT (447) should be applied. Wait 2-3 hours and then sand (180-200) the surface, clean it of the sanding dust and apply the second coat. If you are going to apply the third coat then the surface should be sanded (300-400) 2-3 hours after applying the second coat, cleaned of dust and applied with the third coat. MEGA AQUA İPEKMAT (447) is applied with DEKOR KADİFE RULO (1065) or with brush. Clean the tools with water after use

THINNING:

Ready to use

DRYING TIME:

(25°C, 65%HR): dries within 2-3 hours

CONSUMPTION:

depending the surface type or coat thickness 1kg. of MEGA AQUA İPEKMAT (447) can cover 8-10 m² (100-120 gr/m²) of area in 1 coat.

NOTE:

During the application the surface temperature should be between +5°C and +30°C

SHELF LIFE:

1 year. The ideal storage temperature is between +10°C and +30°C. (In an unopened original container in cool, safe from freezing and direct influence of the sun rays)

PROBLEMS OCCURING WHILE KEEPING AND USING:

If the varnish is highly thick it is either frozen or stored in a temperature higher than 40° C. if applied without mixing enough the varnish will not be spread on the surface homogeneously and give bad view. The same problem will occur if it is mixed with water. Water based varnish should be applied directly on raw wood. Do not use on surfaces previously applied with cellulosic or synthetic based coatings. Such surfaces should be sanded up to wood and applied after special preparations. If you are having problems like this please contact Technical Service with any problem which you are interested in and take a party number on the container with you

THE MANUFACTURER IS NOT RESPONSIBLE FOR MISUSE

Facebook Twitter