az ru en

Products


Paints

Hammerton paint

FAB HAMMERTON PAINT







DESCRIPTION:

Styrene alkyd-based, hammered metal-looking, air drying finishing paint. Very well adheres to primed and non-primed surfaces.

FEATURES:

Air drying. Does not lose brightness and vitality.

APPLICATION:

FAB HAMMERTON PAINT (202) is used in all kinds of metal goods, pipes and equipments in mining industry, lifts, steel doors, a variety of car spare parts, agricultural machinery, hand tools and electrical accessories. New metal surfaces should be cleaned of dirt, rust and oils before applying FAB HAMMERTON PAINT (202). It should not be applied in the wind and a strong air flow. The paint is to be applied only with the gun. Getting a good view depends on compressor power and the use of gun. To get a perfect look it is recommended to apply the paint with 2-3 atm. powers and in a distance of 25-30sm. It is recommended to apply a distance. Mix the paint thoroughly before using. Thin FAB HAMMERTON PAINT (202) in 10% -20% with FAB CELLULOSIC THINNER (161). Clean the used tools with FAB CELLULOSIC THINNER (161) immediately after use.

THINNING:

FAB HAMMERTON PAINT (202) should be thinned with 10%-20% of FAB CELLULOSIC THINNER (161).

DRYING TIME:

(25°C/65%HR): touch dry: 15-20 minutes, powder dry: 30 minutes, full drying: 2 hours, hardening: 24 hours.

FLASH RATE:

<23°C.

CONSUMPTION:

Depending on proper working, gun wastes, and the surface 1 liter of FAB HAMMERTON PAINT (202) can cover ​​10-12m2.

NOTE:

During the application the surface temperature should be between +10°C and +35°C.

SHELF LIFE:

18 months (in an unopened original box in cool, safe from freezing and direct influence of the sun rays).

WARNING:

R11 easily flammable. R20/21/22 - smelling, swallowing, contact with skin and eyes is harmful to health.

SAFETY MEASURES:

S 2 Keep far from children. S 3/7/9 Keep in cool and well-ventilated places in closed container. S 16 Keep away from the sources of fire; don't smoke while applying. S 51 Should be used in good ventilated places.

PROBLEMS OCCURING WHILE KEEPING AND USING:

It is necessary to set the correct air in the compressor in order to avoid dampness in it. In the output of the compressor there must be an air stipulator, otherwise there may be holes in the paint. At the same time if the pressure is high or if applied in very close distance to the surface holes can be formed on the surface. The excessive thick layers or the excessive use of the thinners can cause flowing and waving view. If the surface is too dirty the paint can come unstuck and be stripped off. If you are having problems like this please contact Technical Service with any problem which you are interested in and take a party number on the container with you.

THE MANUFACTURER IS NOT RESPONSIBLE FOR MISUSE.

Facebook Twitter