az ru en




Cement based water resistant ceramic tile adhesive.


For adhesion of small and medium sized ceramic tiles with absorption rate more than %3 in cements based horizontal and vertical internal walls and floors and concrete screeds. The surface should be free of dust, dirt, oil and etc.


6-7 lt. of clean water is mixed with 25 kg. of powder (%24-28). It is advised to use a slow rotating mixer for mixing. Let the mortar rest for 5 minutes, then mix again before using.
Pot life: the mixture should be used within 3 hours after preparing.
Tile applying time: 30 minutes under normal conditions in 23ºC (+/-5ºC) substrate and ambient temperature and %50 humidity. The applying time can change depending on the place and surface temperature and humidity.
The ambient temperature should be around +5ºC and 35ºC. Spread FABKIM STANDARD over the surface, and then adjust the thickness with the suitable notched trowel.
Place the tiles and press them down smoothly then using a rubber hammer place the tiles correctly on their places. Use double bonding (wall and backside of the tile) for the tiles exceeding 33x33cm. For bonding bigger tiles please consult technical service. Before the application of high porous surfaces, apply FABKIM FILM. Grouting should be done at least 24 hours after fixing.


The values change according to site conditions. Kg. of powder per 1m2 Spreader U6 U9 6X6X6 9X9X9 Single bonding 3-4 4-5 Double bonding 5-6 6-8


1 year if stored in original bags in dry conditions.


Do not add extra water into paste. For more information please refer to technical data sheet.

Facebook Twitter