az ru en

Products


Other

FAB TRANSFER PRIMER







DESCRIPTION:

Acrylic copolymer based, ideally adhering to all kinds of surfaces, covering interior and exterior transfer primer especially used for transferring from synthetic paints to water based paints, creates ideal surfaces for the application of emulsions

FEATURES:

FAB KEÇİD ASTARI ideally adheres to the surfaces painted with synthetic paints or very old emulsions, creates ideal film for water based coverings. Makes a bridge between paint and surface and reduces consumption of finishing paint. Can be used as transfer primer for applying emulsions on such hard surfaces as concrete, plaster and so on. Odorless, ecological, environmental friendly

APPLICATION:

The surfaces prior to the application should be dry, cleaned of dust, dirt and oils, roughness should be smoothed. Before using this primer it is necessary to sand the surfaces previously painted with synthetic and water based paints. Parts needing repair (swollen parts, cracks, etc.) should be repaired with FAB AKRİLİK MƏCUN at exterior surfaces. Later the repaired parts together with old painted parts should be sanded and cleaned of sands. When the surface is ready mix FAB KEÇİD ASTARI with maximum 10% of water and apply with the help of DEKOR EXPORT RULO (1080), brush or pulverizing. Wash the tools with water after use

THINNING:

Maximum 10% of water

DRYING TIME:

(25°C, 65%HR) dries within 1 hour, can be covered with paint after 7-8 hours, full drying – 24 hours (25°C, 65%HR)

CONSUMPTION:

depending on the smoothness and absorption of the surface 1kg. of FAB KEÇİD ASTARI can cover 8-10 m2 of area in 1 coat (at wet film thickness of 100-110µ, mixed with water to 10%)

NOTE:

During the application the surface and room temperature should be between +5°C and +30°C

SHELF LIFE:

2 years. The ideal storage temperature is between +10°C and +30°C. (In an unopened original container in cool, safe from freezing and direct influence of the sun rays)

SAFETY MEASURES:

S 2 Keep far from children. S 46 If swallowed immediately call for a doctor and show him the box or label

PROBLEMS OCCURING WHILE KEEPING AND USING:

Incrustation in closed container is caused by air leakage; sediment is caused by keeping in a colder or hotter environment. The excessive thick coat of primer or the excessive use of thinners can cause flowing and waving look. If the surface is too dirty the primer can come unstuck and be stripped off. Light cracks appearing after the application of primer are caused by hot surface while priming and windy weather. The direct sun rays falling on the wall being primed can cause poor adhesion of the primer because of its fast drying. If you are having problems like this please contact Technical Service with any problem which you are interested in and take a party number on the container with you

THE MANUFACTURER IS NOT RESPONSIBLE FOR MISUSE

Facebook Twitter